MrMxyzptlk wrote:It works like a charm. De-noise is a little bit slower, but giving that it really seams to give better results, I presume it is because of the complexity of the algorithm so I don't really care for the extra few seconds.
The only problem I have found so far: when I read a FIT file for processing and than try to save it, until now, it told me that it will save in TIF because current format isn't available for saving, and than it saved in TIF. Now, it gives me a message that only TIF and JPG formats are available for saving, and does not automatically save it in TIF but takes me back to the main interface. The work around is to manually enter the extension after the file name, but I think if I work with an unsupported format for saving than it should take me automatically for the best available format to save (TIF in this case) without throwing me back to the main interface.
trobbet wrote:Thanks Ivo!
I have found that using the Life module in the past, (usually "Isolate"), works well with my often noisy images to help reduce noise before the final Wavelet Denoise module. Twice in using Life/Isolate in ST 1.4 now, I get more noise than I had originally. Using the same two images, in the previous release, does not have this effect. Is this intentional for some reason?
trobbet wrote:I have tried it on 3 separate data sets now, and more than once on at least one set. It happens every time I do it, and I know how to use this module pretty well.
Users browsing this forum: No registered users and 1 guest