StarTools

Hi
I did a process today and went to repeat it as I liked all but one aspect, my last step was to lift the skyglow but keeping the process as was.
On looking at the log later there was no recording that I had kept the data as was and did not do a new global stretch from the question asked on loading the module.
1.7.456
I have now checked if the same occurs with autodev when re-entering after a stretch had previously being done and the selected response is not in the startools log either. Log entry for both re visits to filmdev and autodev in the same processing session (they were done as separate tests).

Please could we update the log to record the question response.

--- Photographic Film Development Emulation
Parameter [White Calibration] set to [Use Stars]
Parameter [Gamma] set to [1.00]
Parameter [Skyglow] set to [3 %]
Parameter [Digital Development] set to [Off]
Parameter [Blue Luminance Contrib.] set to [100 %]
Parameter [Green Luminance Contrib.] set to [100 %]
Parameter [Red Luminance Contrib.] set to [100 %]
Parameter [Dark Anomaly Headroom] set to [5 %]
Parameter [Dark Anomaly Filter] set to [2.0 pixels]

--- Auto Develop
Parameter [Ignore Fine Detail <] set to [Off]
Parameter [Outside RoI Influence] set to [15 %]
Parameter [RoI X1] set to [493 pixels]
Parameter [RoI Y1] set to [529 pixels]
Parameter [RoI X2] set to [980 pixels (-964)]
Parameter [RoI Y2] set to [961 pixels (-335)]
Parameter [Detector Gamma] set to [1.00]
Parameter [Shadow Linearity] set to [50 %]

Thank you,

I have updated 1.7 to show this now.

brilliant thank you